Host Installation
Host-axis was should be the level and the ends of the hollow shaft should in the same height, but it is allowed that the feed-side higher than the discharge end about 1mm. The gap surrounding the hollow shaft should be basically the same as surrounding the bearing gland.
Transmission part installation
The host installation, the installation of transmission part can begin. Firstly, you should check the assembly of the transmission part, mainly examine whether the pinion shaft and the reducer of low-speed shaft is concentric.
Install and adjust the transmission part based on the host’s large gear, So that the width of the both sides of the pinion gear is the same as the large gear, gear tooth surface of the large gear are parallel to the pinion gear and gear backlash should be at least 0.25mm. From the size of the gear contacts traces to see, the length of contacts traces should be at least 60% of the length of the gear and the height of contacts traces should be at least 40% of the height of the gear.
If the contacts traces lean to the one side, namely, that tooth surface is not parallel. If the large gear is jammed, namely, the gap between the gears is too small, which should be enlarged.
Ball mill is an efficient tool for grinding many materials into fine powder. The Ball Mill is used to grind many kinds of mine and other materials, or to select the mine. It is widely used in building material, chemical industry, etc. There are two ways of grinding: the dry process and the wet process. It can be divided into tabular type and flowing type according to different forms of discharging material.
The ball mill is a key equipment for regrinding. It is widely used for the cement, the silicate product, new type building material, fire-proof material, chemical fertilizer, black and non-ferrous metal, glass, ceramics and etc. Our ball mill can grind ore or other materials that can be grinded either by wet process or by dry process.
